(Example: Press the – key for zone 1, press – for zone 12.) Step 4 Enter a 2 digit zone indicating the zone you wish to bypass. The following steps are used for bypassing zones: If you wish to bypass one or more zones, this must be done while the system is in the disarmed state. If a valid code is not entered before the end of the entry delay, an alarm will occur. After entering a valid code the red armed light will go off and the tone will stop. When you enter the protected area through one of the designated Entry/Exit doors, the code pad control will sound a solid continuous tone for the duration of the entry delay time, or until you enter a valid user code. This is ideal for a maid or baby sitter code, etc. This feature is used for ARMING ONLY, and should not be enabled to disarm the security system. The system can be quick armed in the PARTIAL mode by pressing the key. Quick Arm will allow the user to arm the security system in the ON mode by pressing the key. The Quick Arm feature may be used if it is enabled.

USING THE QUICK ARM: (Optional, if programmed) The light(s) corresponding to the bypassed zone(s) will illuminate, alerting the user that a zone(s) may be unprotected and can be faulted without an alarm. The bypass light will illuminate if any zone(s) is bypassed. If the power light is off, you have no AC power. The security system will not arm if the ready light is not on or flashing. NOTE: If any zones are bypassed, a sensor in that zone can be violated without affecting the ready light. Ready light must be on or flashing when all protected zones and sensors are secure. Listed below are the steps to arm in the PARTIAL Mode: PARTIAL is used when the user is inside the premise and wants protection around the perimeter. The user may wish to press the key to start the exit delay again or disarm and rearm the system if more time is needed. NOTE: The exit light will flash rapidly for the last 10 seconds of the exit delay as a warning to the user that the exit time is about to expire. The armed and exit lights will illuminate. Step 2 Enter your 4 or 6 digit user code to arm the system. Ready light will be on or flashing when all protected zones and sensors are secure. Step 1 Close all protected doors and windows. Listed below are the steps to arm in the ON Mode: ON is used when the user is away from the premise and wants the interior protected.

Networx alarm panel manual